How To Install Mower Blades Correctly

Disengage the blade lever and lower the mower deck. Blades can get damaged over time.

How To Change A Lawn Mower Blade 7 Steps With Pictures

Loosen the retaining bolt on the blade.

How to install mower blades correctly. Turn the blade and find the cutting edge on one end. Plus a couple tricks and tips. How to Install Riding Lawnmower Blades step by step Step 1.

Depending on your situation detach the mower deck by removing the connections with the mowers frame. Since the blade damaged due to being upside down we should replace it properly very quickly. Installing a lawnmower blade incorrectly can sometimes result in it not even cutting the grass at all.

We have to find out. Below are some ways to accurately represent the blade of this mower. In this video I demonstrate on my Troy-Bilt Pony how to change your riding lawn mower blades without taking off your deck.

Disconnect the spark plug cables. How to put a blade on and take it off. If there are any sizable dents or if the blade is bent it needs to be sharpened or completely replaced.

Mark the bottom of the blade with a permanent marker grease pencil or spray paint. Most blades have this stamp. I switch out my regular blades fo.

A dull or bent mower blade tatters grass tips rather than making a clean cut leaving the law. If it rock then heres what you should do- ensure that its fitted on the shaft correctly and tight all the securing bolts using a socket wrench. Use a ratchet or socket wrench to loosen the nut until the mower blade.

Dont get that blade upside-down. One of the best ways to determine the proper orientation of a mower blade is to pay attention to how the old blade was mounted. These blades usually have 2 sides an angled side and a flat side.

The cutting edge is sharpened to a point with an. Consider placing a wooden block under the blade to prevent it from moving around. That way you can install the sharpened blade right-side up later.

Which makes your replacement work easier. This video shows how to replace a blade on a riding lawn mower. Sometimes the easiest way to tell if theres a mower blade issue is looking at the blade itself.

For your lawnmower to perform in tip-top shape and ensure that you get the job done you first need to install your blades properly. Lawn mower blades are sharp so youll want to keep your hands protected. How to Know if You Have Your Lawn Mower Blades on Correctly Step 1.

Find the nut that holds the mower blade to the deck. Make sure that the mowers spark plug is disconnected and tilt the mower so that you can access the blade. The Blade is Dented or Bent.

Most new blades have wording stamped on the blade to indicate which side should face the ground when you install. Turn the mower blades slowly until one points forward and one points backward. Hold the blade with a leather glove then remove the bolt or bolts holding it to the mounting plate.

There is a stamp in front of each blade to place the blade properly. Which side of the lawn mower blade is up. To perform the wobble test hold one first of the mower blade firmly and the deck with your other hand.

Use a socket wrench turning left for a standard bolt and right for a reverse-threaded one. Leave this as is and place a wood block inside the deck next to the edge of a blade that has to be aligned.

How To Replace A Lawn Mower Blade Repair Guide